Jump to content

Weatherproofing a Felt Tricorn...


Recommended Posts

I live in the Sunny South, where beeswax plus anything would equal a permanently soggy chapeau.

I have treated my felt hats with a mixture of shellac (1 part white, 3lb. cut) and denatured alcohol (2 parts).

Brush on, let it soak in, then repeat on both sides until you have the desired degree of saturation.

It dries nicely, plus it helps maintain the shape of the hat over the long run.

Just a thought.

Red Sea Trade

In days of old when ships were bold just like the men that sailed 'em,

and if they showed us disrespect we tied 'em up and flailed 'em,

often men of low degree and often men of steel,

they'd make you walk the plank alone or haul you 'round the keel.

--Adam and the Ants

Link to comment
Share on other sites

Sounds good, for I too live in the south and wouldn't want that to happen to my hats. I one question though, what do you mean by 1 part white, 3lb cut? I not sure I understand. 3lb cut, is that the type of felt? And the shellac is white? Thanks again for your insight.

Link to comment
Share on other sites

Sounds good, for I too live in the south and wouldn't want that to happen to my hats. I one question though, what do you mean by 1 part white, 3lb cut? I not sure I understand. 3lb cut, is that the type of felt? And the shellac is white? Thanks again for your insight.

White 3 lb cut is the type of shellac. Mix one part of that with 2 parts denatured alcohol.

The Dread Pyrate MacAnselan

aka Mick

Link to comment
Share on other sites

Yes thanks again. The hats turned out great! Hard as a rock, but they shpaed beautifully while they were wet. I was able to get minw to sit just right on my head. Had to steam and reshape my wifes a bit, but it came out great also. Thanks. I'll post some pics when I get the camera back.

Link to comment
Share on other sites

I cheated, but it worked out great.

I rubbed fabric paint into my felt hat. It's a polymer, and imbues a complete waterproof finish. The only clean-up was getting the stuff off my fingers. It looks great (and, yes, it dried virtually rock-hard, but that helps hold its shape)

04de8cfe.jpg

"He's a Pirate dancer, He dances for money, Any old dollar will do...

"He's a pirate dancer, His dances are funny... 'Cuz he's only got one shoe! Ahhrrr!"

FH1040.jpg

Link to comment
Share on other sites

Actually, this was a hold-over from my (financially) cutting corners in creating my Civil War kit. I made a completely authentic haversack out of canvas according to U.S. military plans... but had to "tar" it. I had discovered some time earlier that black polymer fabric paint (available in most craft and fabric stores) when rubbed into the fabric, made it look as if it had been tarred, and was then waterproof.

After using that haversack for about twelve years, the "tar" had really started to wear off. Just last winter, I took a new bottle of fabric paint, re-applied it, and the decade-old haversack now looks as good as new.

Ever since I saw Bilgemunkey's tarred hat (last year) I had been wanting to try the paint on a felt hat blank... again, I am quite happy with the result.

04de8cfe.jpg

"He's a Pirate dancer, He dances for money, Any old dollar will do...

"He's a pirate dancer, His dances are funny... 'Cuz he's only got one shoe! Ahhrrr!"

FH1040.jpg

Link to comment
Share on other sites

  • 2 years later...
SO I was thinking of using beeswax and some sort of oil. Then heating it up to combine the ingredients. Next brshing it on and seeing what happens. Any suggestions? I'm not sure what is normally used.

Rather old thread I'm bringing up here but I would like to note I used a 1/2 pound of white beeswax and about 1/3 cup of hemp oil melted it down and brushed it on. It didn't seem to absorb as much as wanted it to so I a little bit more on the hat and threw it in the oven for a few minutes on low to melt the wax into the felt and then let it cool. The hat is hard but not too hard and the outside is water proof while the inside is still like normal felt which helps to absorb sweat from my big head. I love the damned thing.

Link to comment
Share on other sites

If you can find a hat made of beaver felt (as opposed to rabbit).

It will be much more water resistant than less expensive hats.

I have had good results treating cheaper hats with Scotchguard.

I have a recipe for a home made water proofing from at least as

far back as the 18th century. It may be older than that. I'll look

for that book when I go home tomorrow and I'll post the recipe.

Edited by CaptainSatan

As we say in Ireland let's drink until the alcohol in our system destroys our liver and kills us.

guns_boobies2.jpg

Link to comment
Share on other sites

OK I checked the limited resource materials that I have at the house.

The earliest waterproofing that I could find was from 1758.

"The cloth was water-proofed by coating it with a boiled linseed and

"litharge of gold" (lead oxide). After several coats of the oil preparation

were dry, the cloth was well sealed and remained flexible."

I also found a post period home made recipe.

Canvas Waterproofing

1 cup soybean oil

1/2 cup turpentine

Mix ingredients together in a bowl and apply with a brush.

Edited by CaptainSatan

As we say in Ireland let's drink until the alcohol in our system destroys our liver and kills us.

guns_boobies2.jpg

Link to comment
Share on other sites

A thinned bitumen paint like you can buy in a hardware store painted on the hat and allowed to cure, pref somewhere dry and ventilated. Hard as nails and waterproof.

A few layers it still looks like felt but solid, many layers make it suede like, lots of layers it looks like a semi polished leather.

Lambourne! Lambourne! Stop that man pissin' on the hedge, it's imported.

Link to comment
Share on other sites

Well, what I did ain't PC, but it don't change the look of the hat.

I got a big can of silicone waterproofing spray from the hardware store.

Great stuff. I've used it on all sorts of things. Gotta keep the stuff hanging in the garage while it cures.

No visible change, no hardening, no greasy feel, water rolls right off.

*Oops!* Just saw the earlier post about Camp Dry...that's the stuff!

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...
&ev=PageView&cd%5Bitem_id%5D=8110&cd%5Bitem_name%5D=Weatherproofing+a+Felt+Tricorn...&cd%5Bitem_type%5D=topic&cd%5Bcategory_name%5D=Thieves Market"/>